CLI Reference Guide

702 | show ap config Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description
the AP. If enabled, this feature converts multicast traffic to
unicast before delivery to the client, thus allowing you to set
a longer DTIM interval. The longer interval keeps
associated wireless clients from activating their radios for
multicast indication and delivery, leaving them in power-
save mode longer and thus lengthening battery life
Drop Broadcast and Multicast
If this feature is enabled on an AP, it drops all downstream
broadcast or multicast traffic to increase battery life.
WEP Key 1
Displays the static WEP key (1 of 4).
WEP Key 2
Displays the static WEP key (2 of 4).
WEP Key 3
Displays the static WEP key (3 of 4).
WEP Key 4
Displays the static WEP key (4 of 4).
WEP Transmit Key Index
Displays the key index that specifies which static WEP key
is to be used.
WPA Hexkey
Displays the WPA pre-shared key (PSK).
WPA Passphrase
Displays the WPA passphrase with which the AP generates
a pre-shared key (PSK).
Maximum Transmit Failures
Display the maximum number of transmission failures
allowed before the client gives up.
BC/MC Rate Optimization
Shows if the AP has enabled or disabled scanning of all
active stations currently associated to that AP to select the
lowest transmission rate for broadcast and multicast
frames. This option only applies to broadcast and multicast
data frames; 802.11 management frames are transmitted at
the lowest configured rate.
Rate Optimization for delivering EAPOL
frames
Shows if the AP has enabled or disabled rate optimization
for delivering EAPOL frames.
Strict Spectralink Voice Protocol (SVP)
Shows if strict Spectralink Voice Protocol (SVP) is enabled
or disabled.
802.11g Beacon Rate
Sets the beacon rate for 802.11g for APs use a Distributed
Antenna System (DAS). Using this parameter in normal
operation may cause connectivity problems.
802.11a Beacon Rate
Sets the beacon rate for 802.11a for APs use a Distributed
Antenna System (DAS). Using this parameter in normal
operation may cause connectivity problems.
Advertise QBSS Load IE
Shows if the AP has enabled or disabled the advertising of
QBSS in the load IE.
High throughput enable (SSID)
Shows if the AP has enabled or disabled the use of its high-
throughput SSID in 40 MHz mode.
40 MHz channel usage
Determines if this high-throughput SSID allows high-
throughput (802.11n) stations to associate.