Manualshelf

CLI Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect W-6000
721722723724725726727728729730
726 | show ap debug client-table Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
show ap debug client-table
show ap debug client-table [ap-name <ap-name>|bssid <bssid>|ip-addr <ip-addr>]
Description
Show clients associated to an AP.
Syntax
Parameter Description
ap-name <ap-name>
Filter the AP Config table by AP name.
bssid <bssid>
Filter the AP Config table by BSSID. The Basic Service Set Identifier (BSSID) is usually the
AP’s MAC address.
ip-addr <ip-addr>
Filter the AP Config table by IP address by entering an IP address in dotted-decimal format.
Usage Guidelines
The Tx_Rate, Rx_Rate, Last_ACK_SNR, and Last_Rx_SNR columns shown in the output of this command display
valuable troubleshooting information for clients trying to connect to a specific AP. Use this command to verify that
the transmit (Tx_Rate) and receive (Rx_Rate) rates are not too low, and that the signal-to-noise (SNR) ratio is
acceptable.
Examples
The example below shows part of the AP configuration table for a specific BSSID. Additional parameters not
displayed are described in the table below.
(host) #show ap debug client-table ap-name AP12
MAC ESSID BSSID Assoc_State HT_State AID PS_State UAPSD
--- ----- ----- ----------- -------- --- -------- -----
Tx_Pkts Rx_Pkts PS_Qlen Tx_Retr
------- ------- ------- -------
00:17:f2:4d:01:e2 wpa2 00:1a:1e:11:5f:11 Associated None 0x1 Awake (0,0,0,0,N/A,0)
31463 22821 0 4289
00:14:a4:25:72:6d wpa2 00:1a:1e:11:5f:11 Associated None 0x2 Awake (0,0,0,0,N/A,0)
24691 45215 0 944
00:19:7e:66:89:38 wpa2 00:1a:1e:11:5f:11 Associated None 0x4 Awake (0,0,0,0,N/A,0)
7031 24739 0 671
00:16:cf:bc:0e:ce wpa2 00:1a:1e:11:5f:11 Associated None 0x5 Awake (0,0,0,0,N/A,0)
3920 14797 0 286
00:19:7d:d6:74:93 wpa2 00:1a:1e:11:5f:11 Associated None 0x7 Awake (0,0,0,0,N/A,0)
2530 8034 0 365
UAPSD:(VO,VI,BK,BE,Max SP,Q Len)
HT Flags: A - LDPC Coding; W - 40Mhz; S - Short GI; M - Max A-MSDU
D - Delayed BA; G - Greenfield; R - Dynamic SM PS
Q - Static SM PS; N - A-MPDU disabled
The output of this command includes the following information: