CLI Reference Guide

744 | show ap debug received-config Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
show ap debug received-config
show ap debug received-config {ap-group <ap-group>|ap-name <ap-name>|bssid <bssid>|ip-addr
<ip-addr>}
Description
Show the configuration the AP downloaded from the controller.
Syntax
Parameter Description
ap-name <ap-name>
Show log information for an AP with a specific name.
bssid <bssid>
Show log information for a specific Basic Service Set Identifier (BSSID). The Basic Service
Set Identifier (BSSID) is usually the AP’s MAC address.
ip-addr<ip-addr>
Show log information for an AP with a specific IP address by entering an IP address in
dotted-decimal format.
Example
The output of this command displays configuration information for each interface. The example below shows only
part of the output for this command. Additional parameters not displayed are described in the table below.
(host) #show ap debug received-config ap-name AP12
Downloaded Config for WIFI 0
----------------------------
Item Value
---- -----
BSSID 00:1a:1e:11:5f:10
LMS IP 10.6.2.250
Master IP 10.100.103.2
Mode AP Mode
QBSS Probe Response Allow Access
Native VLAN ID 1
SAP MTU 1500 bytes
Heartbeat DSCP 0
High throughput enable (radio) Enabled
Channel 40-
Beacon Period 100 msec
Transmit Power 15 dBm
Advertise TPC Capability Disabled
Enable CSA Disabled
CSA Count 4
Management Frame Throttle interval 1 sec
Management Frame Throttle Limit 20
Active Scan Disabled
VoIP Aware Scan Enabled
Power Save Aware Scan Enabled
Load aware Scan Threshold 1250000 Bps
40 MHz intolerance Disabled
Honor 40 MHz intolerance Enabled
Legacy station workaround Disabled