CLI Reference Guide

Country Code US
ESSID guest
...
The output of this command includes the following information:
Parameter Description
BSSID
The BSSID of the AP.
LMS IP
The LMS IP is the IP address of the local controller used by the AP for client
data processing.
Master IP
For environments with multiple controllers, the master controller is the central
configuration and management point for all local controllers.
Mode
Shows the operating modes for the AP.
ap-mode: Device provides transparent, secure, high-speed data
communications between wireless network devices and the wired LAN.
am-mode: Device behaves as an air monitor to collect statistics, monitor
traffic, detect intrusions, enforce security policies, balance traffic load, self-
heal coverage gaps, etc.
QBSS Probe Response
Quality-of-service BSS (QBSS).
Native VLAN ID
The ID number of the Native VLAN.
SAP MTU
The Maximum Transmission Unit (MTU) for the GRE tunnel.
Heartbeat DSCP
DSCP value for the heartbeat traffic between the AP and the controller.
High throughput enable
(radio)
Shows if high-throughput (802.11n) features on tare enabled or disabled on the
radio.
Channel
Shows the channel number for the AP’s 802.11a/802.11n physical layer.
Beacon Period
Shows the time, in milliseconds, between successive beacon transmissions.
The beacon advertises the AP’s presence, identity, and radio characteristics
to wireless clients.
Transmit Power
Shows the current transmission power level.
Advertise TPC Capability
If enabled, the AP will advertise its Transmit Power Control (TPC) capability.
Enable CSA
Displays whether or not the AP has enabled channel switch announcements
(CSAs) for 802.11h.
CSA Count
Number of channel switch announcements that must be sent before the AP
will switch to a new channel.
Management Frame Throttle
interval
Average interval that rate limiting management frames are sent from this
radio, in seconds. If this column displays a zero (0), rate limiting is disabled for
this AP.
Management Frame Throttle
Limit
Maximum number of management frames that can come from this radio in
each throttle interval.
Active Scan
Displays whether or not the active scan feature is enabled.
This option elicits more information from nearby APs, but also creates
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap debug received-config | 745