CLI Reference Guide

Column Description
BA AMSDU Enable
Shows of the AP has enabled or disabled the ability to
receive AMSDU in BA negotiation.
High throughput enable (SSID)
Shows if 802.11n high-throughput features are enabled or
disabled for this profile. By default, high-throughput
features are enabled.
Legacy stations
Allow or disallow associations from legacy (non-HT)
stations. By default, this parameter is enabled (legacy
stations are allowed).
Low-density Parity Check
If enabled, the AP will advertise Low-density Parity Check
(LDPC) support. LDPC improves data transmission over
radio channels with high levels of background noise.
Maximum number of spatial streams usable
for STBC reception
Shows the maximum number of spatial streams usable for
STBC reception. 0 disables STBC reception, 1 uses STBC
for MCS 0-7. Higher MCS values are not supported.
(Supported on the W-AP90 series, W-AP130 series, W-
AP68, W-AP175 series and W-AP105 only. The configured
value will be adjusted based on AP capabilities.)
Maximum number of spatial streams usable
for STBC transmission
Shows the maximum number of spatial streams usable for
STBC transmission. 0 disables STBC transmission, 1 uses
STBC for MCS 0-7. Higher MCS values are not supported.
(Supported on W-AP90 series, W-AP175 series, W-AP130
series and W-AP105 only. The configured value will be
adjusted based on AP capabilities.)
MPDU Aggregation
Shows if the profile enables or disables MAC protocol
data unit (MPDU) aggregation.
Max received A-MPDU size
Configured maximum size of a received aggregate MPDU,
in bytes.
Max transmitted A-MPDU size
Configured maximum size of a transmitted aggregate
MPDU, in bytes.
Min MPDU start spacing
Configured minimum time between the start of adjacent
MPDUs within an aggregate MPDU, in microseconds.
Supported MCS set
Displays a list of Modulation Coding Scheme (MCS) values
or ranges of values to be supported on this SSID. The MCS
you choose determines the channel width (20MHz vs.
40MHz) and the number of spatial streams used by the
mesh node.
Short guard interval in 20 MHz mode
Shows if the profile enables or disables use of short
(400ns) guard interval in 20 MHz mode.
Short guard interval in 20 MHz mode
Shows if the profile enables or disables use of short
(400ns) guard interval in 40 MHz mode.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap mesh-ht-ssid-profile | 795