CLI Reference Guide

826 | show ap provisioning DellPowerConnect W-Series ArubaOS 6.2 | Reference Guide
Column Description
Installation
Indicates the type of installation (indoor or outdoor). The default parameter
indicates that the installation mode is determined by the AP model type.
Latitude
Latitude coordinates of the AP, in the format Degrees Minutes Seconds (DMS).
Longitude
Longitude coordinates of the AP, in the format Degrees Minutes Seconds (DMS).
Altitude
Altitude, in meters, of the AP. This parameter is supported on outdoor APs
only.
Antenna bearing for 802.11a
Horizontal coverage distance of the 802.11a (5GHz) antenna from true north, from 0-
360 degrees.
NOTE: This parameter is supported on outdoor APs only. The horizontal coverage
pattern does not consider the elevation or vertical antenna pattern.
Antenna bearing for 802.11g
Horizontal coverage distance of the 802.11g (2.4GHz) antenna from true north, from
0-360 degrees.
NOTE: This parameter is supported on outdoor APs only. The horizontal coverage
pattern does not consider the elevation or vertical antenna pattern.
Antenna tilt angle for
802.11a
The angle of the 802.11a (5GHz) antenna. This parameter can range from between -
90 degrees and 0 degrees for downtilt, and between +90 degrees and 0 degrees for
uptilt.
Antenna tilt angle for
802.11g
The angle of the 802.11g (2.4GHz) antenna. This parameter can range from between
-90 degrees and 0 degrees for downtilt, and between +90 degrees and 0 degrees
for uptilt.
Mesh SAE
Shows if the AP has enabled or disabled Secure Attribute Exchange (SAE) on a
mesh network.
Related Commands
Command Description
provision-ap
Change provisioning parameters for an individual AP. This command does not save the
provisioning parameters settings in a reusable profile.
ap provisioning-profile
This command defines a provisioning profile for an AP or group of APs.
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.2 Introduced support for mesh parameters, additional antenna parameters, and AP
location parameters.
ArubaOS 3.4 Introduced support for the following parameters:
l Installation
l Mesh SAE
l USB User Name