CLI Reference Guide

show ap remote debug bss-config
show ap remote debug bss-config [ap-name <ap-name>|bssid <bssid>|ip-addr <ip-addr>Description
Show the configuration for each BSSID of an AP. This information can be used to troubleshoot problems on an AP.
Syntax
Parameter Description
ap-name <ap-name>
Filter the AP Config Table by AP name.
ip-addr <ip-addr>
Filter the AP Config Table by IP address by entering an IP address in dotted-decimal
format.
Examples
The output of this command shows the AP configuration table for a specific BSSID.
host) #show ap remote debug bss-config ap-name ap93-3
Dell AP Config Table
---------------------
bss ess vlan ip phy type fw-mode max-cl rates tx-rates preamble mtu
status wmm
--- --- ---- -- --- ---- ------- ------ ----- -------- -------- ---
------ ---
00:1a:1e:11:24:c2 cera2 66 10.6.1.203 g-HT ap tunnel 64 0x3 0xfff enable 0
enable enable
00:1a:1e:8d:5b:11 wpa2 65 10.6.1.198 a-HT ap tunnel 20 0x150 0xff0 - 0
enable enable
00:0b:86:9b:e5:60 guest 63 10.6.14.79 g ap tunnel 20 0x2 0x3fe enable 0
enable enable
00:1a:1e:97:e5:41 voip 66 10.6.1.199 g-HT ap tunnel 20 0xc 0x14c enable 0
enable enable
00:1a:1e:11:74:a1 voip 66 10.6.1.197 g-HT ap tunnel 20 0xc 0x14c enable 0
enable enable
00:1a:1e:11:5f:11 wpa2 65 10.6.1.200 a-HT ap tunnel 20 0x150 0xff0 - 0
enable enable
The output of this command includes the following information:
Column Description
bss
Basic Service Set (BSS) identifier, which is usually the AP’s MAC address.
ess
Extended Service Set (ESS) identifier; a user-defined name for a wireless network.
vlan
The BSSID’s VLAN number.
IP
The AP’s IP address.
phy
One of the following 802.11 types
l a
l a-HT (high-throughput)
l g
l g-HT (high-throughput)
type
This column shows if the BSSID is for an access point (ap) or an air monitor (am).
fw-mode
The configured forward mode for the AP’s virtual AP profile.
l bridge: Bridge locally
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap remote debug bss-config | 843