CLI Reference Guide

854 | show ap spectrum ap-list Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Examples
The output of this example shows spectrum data seen by spectrum monitor ap123. The output in the example
below has been divided into two tables to better fit this document. In the ArubaOS CLI, the output appears as a
single, long table.
(host)# show ap spectrum ap-list ap-name ap123
Spectrum AP Table
-----------------
bssid essid spectrum-id chan phy-type signal(dBm)
----- ----- ----------- ---- -------- ---------------
00:0b:86:cd:22:d0 ECSD Wireless 2 161 80211a 62
00:0b:86:cb:cf:30 ECSD Wireless 3 157 80211a 68
00:0b:86:f6:f6:a0 osuwireless 3 1 80211b/g 48
00:0b:86:f6:f6:a1 osuvoice 4 1 80211b/g 47
00:0b:86:f6:f6:a2 osuguest 5 1 80211b/g 45
avg-rssi(dB) curr-rssi(dB) ibss add-time last-seen
-------- --------- ---- -------- -----------
29 31 no 2010-05-16 17:41:36 2010-05-18 13:39:38
24 25 no 2010-05-16 17:41:36 2010-05-18 14:19:03
37 38 no 2010-05-16 17:41:36 2010-05-18 15:06:02
38 38 no 2010-05-16 17:41:36 2010-05-18 15:04:23
37 40 no 2010-05-16 17:41:36 2010-05-18 15:07:32
The output of this command includes the following information:
Column Description
bssid
Basic Service Set Identifier for an AP. This is usually the AP’s MAC address.
essid
Extended service set identifier that names a wireless network.
spectrum-id
Identifier assigned to the device by the spectrum monitor
chan
Radio channel used by the BSSID
freq-band
Radio phy type. Possible types include:
l 2.4 GHz
l 5 GHz
signal (dBm)
Strength of the signal received by the device, in dBm.
avg-rssi
The average signal-to-noise ratio seen by the AP.
curr-rssi
Most recent signal-to-noise ratio seen by the AP.
ibss
Shows if ad-hoc BSS is enabled or disabled. It will be enabled if the bssid has detected
an ad-hoc BSS (an ibss bit in an 802.11 frame).
add-time
Time when the AP was first detected by the spectrum monitor.
last-seen
Time when the AP was last seen by the spectrum monitor.