CLI Reference Guide
show cluster-config
show cluster-config
Description
Show the multi-master cluster configuration for the control plane security feature.
Usage Guidelines
When you issue this command from the cluster
root
, the output of this command shows the cluster role of the
controller, and the IP address of each member controller in the cluster.
When you issue this command from a cluster
member
, the output of this command shows the cluster role of the
controller, and the IP address of the cluster root.
Example
In the example below, the Cluster Role section in the output of this command shows that the controller on which
the command was issued is the cluster root. The Cluster IPSEC Controllers section of the output shows the IP
address of each cluster member.
(host) (config) #show cluster-config
Cluster Role
------------
Root
----
Cluster IPSEC Controllers
--------------------------
Switch IP address of Cluster-Members Key
------------------------------------ ---
172.21.18.18 ********
172.21.18.19 ********
Related Commands
Command Description Mode
control-plane-security
Configure the control plane security profile. Config mode
cluster-member-ip
This command sets the controller as a control plane security cluster
root, and specifies the IPsec key for a cluster member.
Config mode on
cluster root controllers
cluster-root-ip
This command sets the controller as a control plane security cluster
member, and defines the IPsec key for communication between the
cluster member and the controller’s cluster root.
Config mode on
cluster member
controllers
Command History
This command was introduced in ArubaOS 5.0.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show cluster-config | 917