CLI Reference Guide

984 | show esi ping Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
show esi ping
show esi ping [ping-name <ping-name>]
Description
Show settings for ESI ping health check attributes.
Syntax
Parameter Description
ping-name <ping-name>
Include the optional ping-name <ping-name> parameters to display settings for one
specified set of ping settings.
Example
This example below shows that the controller has three defined sets of ping attributes.
(host) #show esi groups
ESI Ping Table
--------------
Name Frequency (sec) Timeout (sec) Retry Count ID Num Groups
---- --------------- ------------- ----------- -- ----------
ping_att1 5 2 2 0 1
ESIping 5 2 2 1 0
ESIping2 50000 2 2 2 2
The output of this command includes the following information:
Column Description
Name
Name of a group of ping settings.
frequency
Specifies the ping frequency in seconds.
timeout
Specifies the ping timeout in seconds.
retry-count
Specifies the ping retry count
ID
ID number assigned to the ping attributes when that set of attributes was defined.
Num Groups
Number of ESI groups to which this set of ping attributes is assigned.
Related Commands
Platforms Licensing Command Mode
esi ping
This command specifies the ESI ping
health check configuration.
Config mode on master or local controllers.