User's Manual

Predefined Role Permissions
network-operations
(continued)
Monitoring > Network > All Access PointsMonitoring
> Network > All Wired Access Points
You can view the reports created by the following CLI commands:
l DB:opcode=monitor-summary
l DB:opcode=cr-load
l DB:opcode=wlm-search&class=probes&start
l DB:opcode=wlm-search&class=amii
l DB:opcode=monitor-get-all-gps&status=any
l show ap-group
l show vlan status
Monitoring > Controller > Controller Summary
You can view the reports created by the following CLI commands:
l show switches
l show switches summary
Monitoring > Controller > Air Monitors
You can view the reports created by the following CLI commands:
l show wlan-ap start
*
Monitoring > Controller > Clients
You can view the reports created by the following CLI commands:
l show ip mobile host
l show ip mobile trail {<ipaddr> | <macaddr>}
l show esi groups
l show esi servers
l show esi ping
l show esi parser stats
l show private port status
*
l show vlan
l show port stats
l show spanning-tree interface fastethernet <slot/port>
l show interface fastethernet <slot/port> counters
l clear counters fastethernet <slot/port>
l show snmp trap-queue <page>
Monitoring > Controller > Clients > Packet CaptureMonitoring
>Controller > Clients > LocateMonitoring
> Controller > Clients > Debug
You can view the reports created by the following CLI commands:
l aaa user debug mac
Monitoring > Controller> Clients > Disconnect
You can view the reports created by the following CLI commands:
l stm kick-off-sta <macaddr>
l aaa user logout <ipaddr>
network-operations
(continued)
Monitoring > Controller> Clients > Blacklist
You can view the reports created by the following CLI commands:
l stm add-blacklist-client <macaddr>
l aaa user delete {<ipaddr> | all | mac <macaddr> | name
<username> | role <role>}
Monitoring > Controller > Blacklist Clients
You can view the reports created by the following CLI commands:
l stm remove-blacklist-client <macaddr>
Monitoring > Controller > External Services Interface
You can view the reports created by the following CLI commands:
l show esi groups
Dell Networking W-Series ArubaOS 6.4.x | User Guide Behavior and Defaults | 1051