User's Manual

1052 | Behavior and Defaults Dell Networking W-Series ArubaOS 6.4.x| User Guide
Predefined Role Permissions
l show esi servers
l show esi ping
l show esi parser stats
Monitoring > Controller > Ports
You can view the reports created by the following CLI commands:
l show model-switch-internal
*
l show slots
l show private port status
*
l show vlan
Monitoring > Controller> Inventory
You can view the reports created by the following CLI commands:
l show keys
Monitoring > WLAN
You can view the reports created by the following CLI commands:
l DB:opcode=get-permissions
l DB:opcode=cr-load
l show switches
l show switches summary
Monitoring > Voice
You can view the reports created by the following CLI commands:
l show ap association voip-only
l show ap active voip-only
l show voice call-counters
l show voice client status
l show voice call-quality
l show voice call-density
l show voice call-cdrs
l show voice call-perf
Understanding Default Open Ports
By default, Dell controllers and access points treat ports as untrusted. However, certain ports are open by
default only on the trusted side of the network. These open ports are listed in Table 233.
Port
Number
Protocol Where Used Description
17 TCP controller This is use for certain types of VPN clients that accept a
banner (QOTD). During normal operation, this port will
only accept a connection and immediately close it.
21 TCP controller
22 TCP controller SSH
23 TCP AP and
controller
Telnet is disabled by default but the port is still open.
53 UDP controller Internal domain.
Table 233: Default (Trusted) Open Ports