User's Manual
112 | Control Plane Security Dell Networking W-Series ArubaOS 6.4.x| User Guide
Viewing Whitelist Status
The WebUI can display either a table of entries in the selected whitelist, or a general nstatus summary for that
whitelist. The whitelist status pages show the current status each entry in the whitelist, and, for controllers in a
master/local controller topology, information for whitelist synchronization between controllers. This
information is updated automatically as the status of each entry changes.
The Wireless > AP Installation > Whitelist tab displays status information for the campus AP Whitelist by
default. To view status information for entries in the remote AP whitelist, click the blue Remote AP link on this
tab.
The following table describes the status information types available on the Whitelist status page.
Status Entry Description
Control Plane Security
(Campus AP Whitelist status
only)
Shows if control plane security has been enabled or disabled on the
controller. This status entry is also a link to the control plane security
configuration tab.
Number of Entries Total number of entries in the selected whitelist.
Approved Entries Number of entries that have been approved by the controller.
Unapproved Entries Number of entries that have not been approved by the controller
Certified Entries AP has an approved certificate from the controller.
Certified Hold Entries Shows if the controller thinks the AP has been certified with a factory
certificate yet the AP requests to be certified again. Because this is not a
normal condition, the AP is not approved as secure until a network
administrator manually changes the status of the AP to verify that it is not
compromised.
NOTE: If an AP is in this state due to connectivity problems, then the AP
recovers and is taken out of this hold state as soon as connectivity is
restored.
Revoked Entries Number of AP entries that have been manually revoked.
Marked For Deletion Entries Number of APs that have been marked for deletion, but that have not been
removed from the whitelist.
Table 14: Whitelist status information
The Remote AP whitelist entries page displays only the information you manually configure. The entries in the
campus AP whitelist include both user-defined settings and additional AP information that is updated as the
status of the AP changes.