User's Manual

Parameter Description
Cert Type The type of certificate used by the AP.
l switch-cert: The AP is using a certificate signed by the controller.
l factory-cert: The AP is using a factory-installed certificate.
State The Campus AP Whitelist reports one of the following states for each
campus AP:
l unapproved-no-cert: The AP has no certificate and is not approved.
l unapproved-factory-cert: The AP has a preinstalled certificate that
was not approved.
l approved-ready-for-cert: The AP has been approved as a valid
campus AP and is ready to receive a certificate.
l certified-factory-cert: The AP is already has a factory certificate. If an
AP has the factory-cert certificate type and is in the certified-factory-
cert state, then that campus AP is not reissued a new certificate if you
enable automatic certificate provisioning.
l certified-switch-cert: The AP has an approved certificate from the
controller.
l certified-hold-factory-cert: An AP is put in this state when the
controller thinks the AP has been certified with a factory certificate but
the AP requests to be certified again. Because this is not a normal
condition, the AP is not approved as a secure AP until a network
administrator manually changes the status of the AP to verify that it is
not compromised.
NOTE: If an AP is in this state due to connectivity problems, then the AP
recovers and leaves this hold state as soon as connectivity is restored.
l certified-hold-switch-cert: An AP is put in this state when the
controller thinks the AP has been certified with a controller certificate
but the AP requests to be certified again. Because this is not a normal
condition, the AP is not approved as a secure AP until a network
administrator manually changes the status of the AP to verify that it is
not compromised.
NOTE: If an AP is in this state due to connectivity problems, then the AP
recovers and is taken out of this hold state as soon as connectivity is
restored.
Revoked Shows if the AP’s secure status has been revoked.
Revoked Text An optional, brief statement describing why the AP was revoked.
Last Update Time and date of the last AP status update.
Table 15: Additional Campus AP Status Information
To view information about the remote and campus AP whitelists using the command-line interface, use the
commands described in Table 16.
Dell Networking W-Series ArubaOS 6.4.x | User Guide Control Plane Security | 113