User's Manual

Creating and Installing an Internal Captive Portal
If you do not wish to customize the default captive portal page, you can use the following procedures to create
and install a new internal captive portal page. This section describes the following topics:
l Creating a New Internal Web Page on page 323
l Installing a New Captive Portal Page on page 325
l Displaying Authentication Error Messages on page 325
l Reverting to the Default Captive Portal on page 326
l Configuring Localization on page 326
l Customizing the Welcome Page on page 329
l Customizing the Pop-Up box on page 330
l Customizing the Logged Out Box on page 331
Creating a New Internal Web Page
In addition to customizing the default captive portal page, you can also create your own internal web page. A
custom web page must include an authentication form to authenticate a user. The authentication form can
include any of the following variables listed in Table 54:
Variable Description
user (Required)
password (Required)
FQDN The fully-qualified domain name (this is dependent on the setting of the
controller and is supported only in Global Catalog Servers software.
Table 54: Web Page Authentication Variables
Dell Networking W-Series ArubaOS 6.4.x | User Guide Captive Portal Authentication | 323