User's Manual

In the CLI
You must be in config mode to create, modify or delete an ARM profile using the CLI. Specify an existing ARM
profile with the <profile-name> parameter to modify an existing ARM profile, or enter a new name to create an
entirely new profile.
Configuration details and any default values for each of these parameters are described in Table 82. If you do
not specify a parameter for a new profile, that profile uses the default value for that parameter. Put the no
option before any parameter to remove the current value for that parameter and return it to its default
setting.
The ARMprofile includes advanced client match settings that can be configured through the command-line interface
only. The default values for these settings are recommended for most users, and caution should be used when
changing them to a non-default value. For complete details on all client match configuration settings, refer to the Dell
Networking W-Series ArubaOS CLIReference Guide.
Use the following commands to create or modify an ARM profile:
(host)(config) #rf arm-profile <profile>
rf arm-profile <profile>
40MHz-allowed-bands {All|None|a-only|g-only}
80MHz support
acceptable-coverage-index <number>
active-scan (not intended for use)
assignment {disable|maintain|multi-band|single-band}
backoff-time <seconds>
channel-quality-aware-arm
channel-quality-threshold <channel-quality-threshold>
channel-quality-wait-time <seconds>
client-aware
client-match
clone <profile>
cm-blist-timeout <secs>
cm-lb-client-thresh <#-of-clients>
cm-lb-snr-thresh <dB>
cm-lb-thresh <%-of-clients>
cm-max-steer-fails <#-of-fails>
cm-stale-age <secs>
cm-sticky-check_intvl <secs>
cm-sticky-check_snr <dB>
cm-sticky-min-signal <-dB>
cm-sticky-snr-thresh
cm-update-interval <dB>
error-rate-threshold <percent>
error-rate-wait-time <seconds>
free-channel-index <number>
ideal-coverage-index <number>
load-aware-scan-threshold
max-tx-power <dBm>
min-scan-time <# of scans>
min-tx-power <dBm>
mode-aware
multi-band-scan
no ...
ota-updates
ps-aware-scan
rogue-ap-aware
scan mode all-reg-domain|reg-domain
scanning
video-aware-scan
voip-aware-scan
Dell Networking W-Series ArubaOS 6.4.x | User Guide Adaptive Radio Management (ARM) | 442