User's Manual

475 | Wireless Intrusion Prevention Dell Networking W-Series ArubaOS 6.4.x| User Guide
Protecting Windows Bridge
Protecting from a Windows Bridge involves containing the client that is forming the bridge so that it can not
connect to the AP.
Configuring the WLAN Management System (WMS)
The WLAN management system (WMS) on the controller monitors wireless traffic to detect any new AP or
wireless client station that tries to connect to the network. When an AP or wireless client is detected, it is
classified and its classification is used to determine the security policies which should be enforced on the AP or
client.
In the WebUI
1. Navigate to the Configuration > Advanced Services > Wireless page.
2. Configure the parameters, as described in Table 90. Then click Apply.
Parameter Description
Adhoc AP Ageout The amount of time, in minutes, that an adhoc (IBSS) AP unseen
by any problems before it is deleted from the database. Enter 0
to disable ageout.
Default: 30 minutes
AP Ageout Interval The amount of time, in minutes, that an AP is unseen by any
probes before it is deleted from the database. Enter 0 to disable
ageout.
Default: 30 minutes
AM Poll Interval Interval, in milliseconds, for communication between the
controller and Dell AMs. The controller contacts the AM at this
interval to download AP to STA associations, update policy
configuration changes, and download AP and STA statistics.
Default: 60000 milliseconds (1 minute)
Number of AM Poll Retries Maximum number of failed polling attempts before the polled
AM is considered to be down.
Default: 3
Station Ageout Interval The amount of time, in minutes, that a client is unseen by any
probes before it is deleted from the database. Enter 0 to disable
ageout.
Default: 30 minutes
Enable Statistics Update in DB Enables or disables statistics update in the database.
Default: enabled
Collect Stat Enables collection of statistics (up to 25,000 entries) on the
master controller for monitored APs and clients. This only applies
when MMS is not configured.
Default: disabled
Learn System Wired Mac Enable or disable “learning” of wired MACs at the controller.
Default: disabled
Propogate Wired Mac Enables the propagation of the gateway wired MAC information.
Table 90: WMS Configuration Parameters