User's Manual

Parameter Description
Basic Mesh High-Throughput SSID Profile Settings
40 MHz channel usage Enable or disable the use of 40 MHz channels.
Default: enabled
High-throughput Enable
(SSID)
Enable or disable high-throughput (802.11n) features on the SSID.
Default: enabled
Explicit Transmit
Beamforming
Enable/Disable use of Explicit Transmit Beamforming. (For W-AP130 Series
only)
If this parameter is disabled, the other transmit beamforming configuration
settings have no effect.
Transmit Beamforming
Compressed Steering
When enabled, the AP can use explicit compressed feedback from clients to
obtain a steering matrix. (For W-AP130 Series APs only.)
Default: enabled
Transmit Beamforming
non Compressed Steering
When enabled, the AP can use explicit noncompressed feedback from clients
to obtain a steering matrix. (For W-AP130 Series only)
Default: enabled
Transmit Beamforming
delayed feedback support
Enable/Disable delayed feedback/report support in Transmit Beamforming.
(For W-AP130 Series only)
Default: enabled
Transmit Beamforming
immediate feedback
support
Enable/Disable immediate feedback/report support in Transmit Beamforming.
(For W-AP130 Series only)
Default: enabled
Transmit Beamforming
Sounding Interval
Time interval in seconds between updates of Transmit Beamforming channel
estimation. (For W-AP130 Series only)
The supported range is 1-65335 seconds, and the default is 1800 seconds.
Advanced Mesh High-Throughput SSID Profile Settings
Temporal Diversity Enable When a client is not responding to 802.11 packets, the AP will launch two
hardware retries. If you enable this option and hardware retries are not
successful, then the AP will launch then software retries.
BA AMSDU Enable Enable/Disable Receive AMSDU in BA negotiation.
Legacy stations Allow or disallow associations from legacy (non-HT) stations. By default, this
parameter is enabled (legacy stations are allowed).
Low-density Parity Check If enabled, the AP advertises Low-density Parity Check (LDPC) support LDPC
improves data transmission over radio channels with high levels of
background noise. (For W-AP130 Series only)
Maximum number of
spatial streams usable for
STBC reception
Controls the maximum number of spatial streams usable for STBC reception.
0 disables STBC reception, 1 uses STBC for MCS 0-7. Higher MCS values are
not supported. (Supported on the W-AP90 series, W-AP130 Series, W-AP68, W-
AP175 and W-AP105 only. The configured value adjusts based on AP
capabilities.)
If transmit beamforming is enabled, STBC is disabled for disabled for
beamformed frames.
Table 104: Mesh High-Throughput SSID Profile Configuration Parameters
Dell Networking W-Series ArubaOS 6.4.x | User Guide Secure Enterprise Mesh | 557