User's Manual

606 | IP Mobility Dell Networking W-Series ArubaOS 6.4.x| User Guide
wlan virtual-ap default ha-disc-onassoc
Configuring Advanced Mobility Functions
You can configure various parameters that pertain to mobility functions on a controller in a mobility domain
using either the WebUI or the CLI.
In the WebUI
1. Navigate to the Configuration > Advanced Services > IP Mobility page.
2. Select the Global Parameters tab.
3. Configure your desired IP mobility settings. Table 117 describes the parameters you can configure on the
Global Parameters tab.
Parameter Description
General
Encapsulation
Supported
This parameter shows the type of encapsulation currently supported on the
controller.
Clear Trail Entries Clear the station location trail table. You can view entries in this table using the
show ip mobile trail command.
Clear Mobility Counters Clear counters for IP mobility statistics.
Foreign Agent
lifetime Requested lifetime, in seconds, as per RFC 3344, IP Mobility Support for IPv4.
Range: 10-65534 seconds
Default: 180 seconds
Max. Visitors Allowed Set a maximum allowed number of active visitors.
Range: 0-5000 visitors
Default: 5000 visitors
Registration Requests
Retransmits
Maximum number of times the foreign agent attempts mobile IP registration
message exchanges before giving up.
Range: 0-5 attempts
Default: 3 attempts
Registration Requests
Interval
Retransmission interval, in milliseconds.
Range: 100-10000 milliseconds
Default: 1000 milliseconds
Home Agent
Replay Time difference, in seconds, for timestamp-based replay protection, as described
by RFC 3344, IP Mobility Support for IPv4. 0 disables replay.
Range: 0-5000 seconds
Default: 5000 seconds.
Table 117: IP Mobility Configuration Parameters