User's Manual

640 | Remote Access Points Dell Networking W-Series ArubaOS 6.4.x| User Guide
Summary
Table Name
Basic View Information Advanced View Information
associated or just authorized
l Auth: Type of authentication: WPA,
802.1x, none, open, or shared
l Encryption: encryption type used by the
wireless user
l Band: radio band used by the wireless
client
l RSSI: Receive Signal Strength Indicator
(RSSI) value displayed in the output of
this command represents signal strength
as a signal to noise ratio.
Device Info l Type: AP device/model type.
l Name: Name assigned to the AP.
l Wired MAC address: MAC address of
the wired port.
l Serial #: AP serial number.
l Tunnel IP address: IP address of the
tunnel between the AP and controller.
l Software Version: Software version
currently running on the AP.
l Uptime: Amount of time the AP has
been active since it was last reset.
l Master: IP address of the master
controller.
l lms: IP address of the local controller.
N/A
Uplink Info The Uplink Info table can display some or
all of the following information for your
remote AP, depending upon whether a
link is active and the number of links
supported by the AP.
Active uplink information, including:
l Interface name
l Port speed
l IP address
Standby link information, including:
l Name (3G)
l Device connected (yes/no)
l Provisioned (yes/no)
l IP address
l Device
l User
l Password
N/A
Multihoming on remote AP (RAP)
You can uplink a RAP as an Ethernet or a USB based modem. These uplinks can be used as a backup link if the
primary link fails. The uplink becomes active based on the order of priority configured on the RAP. The RAP
switches back to the primary link when the primary connection is restored.
For information on provisioning the RAP using the USB based modem, see Provisioning 4G USB Modems on
Remote Access Points on page 668.
Seamless failover from backup link to primary link on RAP
RAPs can failover from a backup link to a primary link without much disruption to traffic. Also the failover is
performed only if the controller is reachable via the primary link.