User's Manual

674 | Remote Access Points Dell Networking W-Series ArubaOS 6.4.x| User Guide
l Link Priority Cellular—This is a number that identifies the priority of the connection. If the Link Priority
Cellular has a higher number than Link Priority Ethernet, then cellular connection is used.
l Link Priority Ethernet—This is a number that identifies the priority of the connection. If the Link Priority
Ethernet has a higher number than Link Priority Cellular, then Ethernet connection is used.
3. Click Save after you have entered all the details and click Continue to complete provisioning of your RAP.
Configuring W-IAP3WN and W-IAP3WNP Access Points
The DellW-IAP3WN and W-IAP3WNP are single-radio, single-band wireless APs that support the IEEE 802.11n
standard for high-performance WLAN. These APs use MIMO (Multiple-In, Multiple-Out) technology and other
high-throughput mode techniques to deliver high-performance, 802.11n 2.4 GHz functionality while
simultaneously supporting existing 802.11 b/g wireless services.
See the Dell Networking W-Series W-IAP3WN/P Installation Guide for more information.
These access points require Dell Instant 3.0 or later to operate as an Instant AP, or ArubaOS 6.1.4.0 or later to
operate as a Remote AP.
The Power Sourcing Equipment (PSE) functionality is available only for W-IAP3WNP APs, as the PoE itself
provides the PSE functionality for W-IAP3WN APs. You can use the WebUI or CLI to enable or disable the PSE
functionality on the W-IAP3WNP APs.
Using the WebUI
1. Navigate to the Configuration > Advanced Services > All Profiles page.
2. Select the AP tab, then the AP Ethernet Link profile tab.
3. Select the default tab .
4. Select the Power over Ethernet checkbox.
5. Click Apply. Support for W-IAP3WN and W-IAP3WNP access points (APs)
Using the CLI
l To enable, enter:
(host)(config) #ap enet-link-profile <name>
poe
l To disable, enter:
(host)(config) #ap enet-link-profile <name>
no poe
Use the following command to view the PoE port status on an AP:
(host) #show ap enet-link-profile default
AP Ethernet Link profile "default"
----------------------------------
Parameter Value
--------- -----
Speed auto
Duplex auto
Power over Ethernet Disabled
Converting an IAP to RAP or CAP
For IAP to RAPor CAP conversion, the virtual controller sends the convert command to all the other IAPs. The
virtual controller along with the other slave IAPs then set up a VPN tunnel to the remote controller, and