User's Manual

Information Description My Values
AirWave IPaddress IP address of the AirWave server.
SNMP version Specify if the controller and AirWave serer should com-
municate using SNMP v2 or SNMPv3. SNMPv3 com-
munications between a controller and an AirWave server
use SHAauthentication and AES encryption.
For SNMPv2 If you select SNMPv2, you must enter an SNMP com-
munity string.
For SNMPv3 If you select SNMPv3, you must enter values for the fol-
lowing parameters:
l User name : A string representing the name of the
SNMP user.
l Authentication password: Authentication key for use
with the SHA authentication protocol.
l privacy password: Privacy key for encrypted
messages.
l NTP server: If the controller is not already configured
to use an NTP server, enter the IP address of an NTP
server.
Syslog Syslog messages are disabled by default. Use the Syslog
section of the wizard to enable syslog messages, and
define the syslog category, syslog facility levels (local0-loc-
al7) and syslog severity levels (debug-emergency) for mes-
sages from the controller. By default, AirWave syslog
messages sent at the error severity level.
The possible syslog categories are as follows:
l ap-debug
l arm-user-debug
l network
l security
l system
l user
l user-debug
l wireless
Table 157: AirWave Wizard Checklist
Custom Certificate Support for RAP
As Suite-B mandates using the AES-GCM encryption and ECDSA certificates for security, this feature allows you
to upload custom RSA and ECDSA certificates to a RAP. This allows custom certificates to be used for IKEv2
negotiation which establishes a tunnel between the RAP and the controller. Feature support includes the ability
to:
l Upload a single CA certificate and RAP certificate which have either elliptical crypto key parameters with
ECDSA or RSA parameters for signing and verification.
l Store the certificate in the flash of the RAP
l Delete certificates
Dell Networking W-Series ArubaOS 6.4.x | User Guide Management Access | 786