User's Manual

805 | Management Access Dell Networking W-Series ArubaOS 6.4.x| User Guide
Category/Subcategory Description
dot1x 802.1x messages
ike IKE messages
webserver Web server messages
Wireless Wireless messages
all All wireless messages
User User messages
all All user messages
captive-portal Captive portal user messages
vpn VPN messages
dot1x 802.1x messages
radius RADIUS user messages
For each category or subcategory, you can configure a logging level. Table 170 describes the logging levels in
order of severity, from most to least severe.
Logging Level Description
Emergency Panic conditions that occur when the system becomes unusable.
Alert Any condition requiring immediate attention and correction.
Critical Any critical conditions such as a hard drive error.
Errors Error conditions.
Warning Warning messages.
Notice Significant events of a non-critical and normal nature.
Informational Messages of general interest to system users.
Debug Messages containing information useful for debugging.
Table 170: Logging Levels
The default logging level for all categories is Warning. You can also configure IP address of a syslog server to
which the controller can direct these logs.
In the WebUI
1. Navigate to the Configuration > Management > Logging > Servers page.
2. To add a logging server, click New in the Logging Servers section.
3. Click Add to add the logging server to the list of logging servers. Ensure that the syslog server is enabled and
configured on this host. Click Apply.
4. To select the types of messages you want to log, select the Levels tab.