User's Manual

834 | 802.11u Hotspots Dell Networking W-Series ArubaOS 6.4.x| User Guide
Profile Description
H2QP Operating Class
Indication profile
Use this profile to specify the channels on which the hotspot is
capable of operating
For more information on configuring this profile, refer to
Configuring H2QP Operating Class Indication Profiles on page 853
H2QP Operator Friendly Name
profile
Use this profile to define the operator-friendly name sent by
devices using this profile.
For more information on configuring this profile, refer to
Configuring H2QP Operator Friendly Name Profiles on page 852
H2QP WAN Metrics profile Use this profile to specify the WAN status and link metrics for your
hotspot.
For more information on configuring this profile, refer to
Configuring H2QP WAN Metrics Profiles on page 853
Configuring Hotspot 2.0 Profiles
Use this profile to enable the hotspot 2.0 feature, and define venue and OI settings for roaming partners. Each
hotspot 2.0 profile also references an advertisement profile, which defines a set of ANQP or H2QP profiles
which define other values for the hotspot feature. By default, hotspot 2.0 profiles references the default
advertisement profile. For information on associating a different advertisement profile with a hotspot 2.0
profile, see Associating the Advertisement Profile to a Hotspot 2.0 Profile on page 840.
In the WebUI
To configure a hotspot 2.0 profile from the controller WebUI:
1. Navigate to Configuration>Advanced Services>All Profiles.
2. In the profiles list, expand the Wireless LAN section.
3. Select Hotspot 2.0.
4. Select an existing profile from the list of profiles on the profile details pane or create a new profile by
entering a profile name into the entry blank, then clicking Add.
5. Configure the parameters described in Table 175 as desired, then click Apply.
Parameter Description
Advertise Hotspot 2.0 Capability This checkbox enables or disables the hotspot. When this feature
is enabled, the Information Elements (IEs) for this hotspot are
included in beacons and probe responses from the AP.
This setting is disabled by default.
Use GAS Comeback
Request/Response
By default, ANQP Information is obtained from a GAS Request and
Response. If you enable the Use GAS Comeback
Request/Response option, advertisement information is obtained
using a GAS Request and Response. as well as a Comeback-
Request and Comeback-Response. This option is disabled by
default.
Additional Steps required for
Access Enabled
Select this checkbox if any additional steps are required for
network access. If this parameter is enabled, the AP will send the
following Information Elements (IEs) in response to the client’s the
ANQP query.
l Venue Name
Table 175: Hotspot 2.0 Profile Settings