User's Manual

Parameter Description
PAME BI This option enables the Pre-Association Message Exchange
BSSID Independent (PAME-BI) bit, which is used by an AP to
indicate whether the the AP indicates that the Advertisement
Server can return a query response that is independent of the
BSSID used for the GAS Frame exchange.
Downstream Group Frames
Forwarding Blocked
This option configures the Downstream Group Addressed
Forwarding (DGAF) Disabled Mode. If this feature is enabled, it
ensures that the AP does not forward downstream group-
addressed frames. It is disabled by default, allowing the AP to
forward downstram group-addressed frames.
Time Zone Format
The time zone in which the AP is operating, in the format
<std><offset>[dst[offset][,start[/time],end[/time]]
Where the <std> string specifies the abbreviation of the time
zone, <dst> is the abbreviation of the timezone in daylight savings
time, and the <offset> string specifies the time value you must
add to the local time to arrive at UTC.
NOTE: For complete details on configuring the timezone format,
refer to section 8.3 of IEEE Std 1003.1, 2004 Edition.
Time Advertisement Capability This parameter specifies the AP’s source of external time, and the
current condition of its timing estimator.
l no-std-ext-time-src: The AP using this profile has no
standardized external time source.
l timestamp-offset-utc: The AP has a timestamp offset based
on UTC.
l reserved: This setting is reserved for future use, and should
not be used.
Time Error Value
The standard deviation of error in the time value estimate, in
milliseconds. The default value is 0 milliseconds, and the
supported range is 0- 2,147,483,647 milliseconds.
P2P Device Management Issue this command to advertise support for P2P device
management. This setting is disabled by default.
P2P Cross Connect Issue this command to advertise support for P2P Cross
Connections. This setting is disabled by default.
Hotspot 2.0 Advertisement Protocol
Type
Select one of the following advertisement protocol types to be
used by the AP.
l anqp: Access Network Query Protocol (ANQP)
l emergency: Emergency Alert System (EAS)
l mih-cmd-event: Media Independent Handover (MIH)
Command and Event Services Capability Discovery
l mih-info: Media Independent Handover (MIH) Information
Service. This option allows handovers between differing kinds
of wireless access protocols and technologies, allowing access
points on different IP subnets to communicate with each other
at the link level while maintaining session continuity.
l rsvd: Reserved for future use.
Dell Networking W-Series ArubaOS 6.4.x | User Guide 802.11u Hotspots | 837