User's Manual

854 | 802.11u Hotspots Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description
H2QP WAN metrics link
status
Define the status of the WAN Link by clicking the H2QP WAN metrics link status
drop-down list, and selecting one of the following values. The default link status is
reserved, which indicates that the link status is unknown or unspecified
l link down: WAN link is down.
l link test: WAN link is currently in a test state.
l link up: WAN link is up.
l reserved: This parameter is reserved by the Hotspot 2.0 specification, and cannot
be configured.
Default: reserved
H2QP WAN metrics sym-
metric WAN link
Select this checkbox to indicate that the WAN Link has same speed in both the uplink
and downlink directions.
H2QP WAN metrics link
at capacity
Select this checkbox to indicate that the WAN Link has reached its maximum capacity.
If this parameter is enabled, no additional mobile devices will be permitted to
associate to the hotspot AP.
WAN Metrics uplink
speed
This parameter defines the current WAN uplink speed in Kbps. If no value is set, this
parameter will show a default value of 0 to indicate that the uplink speed is unknown
or unspecified.
Range: 0 - 2147483647, Default: 0
WAN Metrics downlink
speed
This parameter defines the current WAN backhaul downlink speed in Kbps. If no value
is set, this parameter will show a default value of 0 to indicate that the downlink speed
is unknown or unspecified.
Range: 0 - 2147483647, Default: 0
WAN Metrics uplink
load
This parameter defines the percentage of the WAN uplink that is currently utilized. If
no value is set, this parameter will show a default value of 0 to indicate that the down-
link speed is unknown or unspecified.
Range: 0-100; Default: 0
WAN Metrics downlink
load
This parameter defines the percentage of the WAN downlink that is currently in use. If
no value is set, this parameter will show a default value of 0 to indicate that the
downlink speed is unknown or unspecified.
Range: 0-100; Default: 0
WAN Metrics load meas-
urement duration
Duration over which the downlink load is measured, in tenths of a second.
Range: 0-65535; Default: 0
Table 185: H2QP WAN Metrics Profile Parameters
In the CLI
To configure a H2QP WAN metrics profile from the controller CLI, access the CLI in config mode and issue the
following commands:
wlan hotspot h2qp-wan-metrics-profile <profile-name>
at-capacity
clone <profile-name>
downlink-load
downlink-speed
load-dur
no ...
symm-link
uplink-load
uplink-speed