User's Manual

889 | Voice and Video Dell Networking W-Series ArubaOS 6.4.x| User Guide
...
5. Configure the dynamic multicast optimization threshold value:
(host) (config) #dynamic-mcast-optimization-thresh 6
(host) #(host} #show wlan virtual-ap default
Virtual AP profile "default"
----------------------------
Parameter Value
--------- -----
Virtual AP enable Enabled
Allowed band all
...
...
...
Blacklist Time 3600 sec
Dynamic Multicast Optimization for Video Enabled
Dynamic Multicast Optimization Threshold 6
Authentication Failure Blacklist Time 3600 sec
...
...
...
6. Configure multicast rate optimization for video traffic:
(host) (config) #wlan ssid-profile default
(host) (SSID Profile "default") #mcast-rate-opt
(host) (SSID Profile "default") #show wlan ssid-profile default
SSID Profile "default"
----------------------
Parameter Value
--------- -----
SSID enable Enabled
ESSID building1-ap
Encryption opensystem
DTIM Interval 1 beacon periods
802.11a Basic Rates 6 12 24
...
...
...
EDCA Parameters Station profile N/A
EDCA Parameters AP profile N/A
BC/MC Rate Optimization Enabled
Strict Spectralink Voice Protocol (SVP) Disabled
...
...
...
7. Configure ARM scanning for video traffic.
In the default RF ARM profile, enable the video aware scan option. This prevents APs from scanning
when a video traffic is active:
(host) (config) #rf arm-profile default
(host) (Adaptive Radio Management (ARM) profile "default") #video-aware-scan
(host) (Adaptive Radio Management (ARM) profile "default") #end
(host) #show rf arm-profile default
Adaptive Radio Management (ARM) profile "default"
-------------------------------------------------
Parameter Value
--------- -----
Assignment single-band
Allowed bands for 40MHz channels a-only
Client Aware Enabled
...