User's Manual

986 | W-600 Series Controllers Dell Networking W-Series ArubaOS 6.4.x| User Guide
The controller can dial (via the modem) your Service Provider to initiate a PPP session. During the boot
sequence, the controller issues your device’s mode-switching command, every few seconds, until the PPP link
connects.
Finding USB Modem Commands
To support the USB cellular modems on the W-600 Series, the cellular profile <profile> and uplink
commands are available at the command line interface. For detailed information on these commands, refer to
the Command Line Reference Guide.
You can view connected USB cellular devices via the Controller > Universal Serial Bus > USB Devices in the
Web UI (see Figure 224). Navigating to this page is the equivalent of executing the show usb command at the
command prompt.
Figure 224 Connected Cellular Devices
Uplink Manager
Access the Uplink Manager feature from the WebUI Configuration tab. Navigate to this feature via Uplink >
Uplink Manager ().
Figure 225 WebUI Uplink Manager
You can enable/disable the uplink to overwrite cellular and wired uplink priority. The corresponding commands
are:
(host) (config)# uplink [enable | disable]
(host) (config)# uplink [cellular | wired] priority [x]
Cellular Profile
The Cellular Profile tab allows you to add/modify/delete one or more cellular profiles. The WebUI screen for
Cellular Profile is divided into the Cellular Profile Table (the top portion) and the Modify Cellular Profile (the
bottom portion). When a cellular profile is selected for modification (see Figure 226) the bottom modify
portion is revealed. All changes are entered into the buffer until the Apply button is executed.