User's Manual

Figure 226 Cellular Profile from the WebUI
Dialer Group
Use the Dialer Group command to configure EVDO devices that require specific input for the initial string (init-
string) and dial string. When adding or modifying an existing dialer group (see Figure 227), the WebUI executes
the following commands:
(host) (config-cellular profile_name)# dialer group <name> init-string <string>
(host) (config-cellular profile_name)# dialer group <name> dial-string <string>
Figure 227 Configuring Dialer Group
Configuring a Supported USB Modem
If your USB Modem is a validated modem, then no configuration is needed. Just follow the “plug and play”
steps below.
1. Insert the USB Modem into an open USB port.
Dell Networking W-Series ArubaOS 6.4.x | User Guide W-600 Series Controllers | 987