Configuration manual

100 | Configuration Reference Dell PowerConnect W-AirWave 7.4 | Configuration Guide

3. Select Add or Save. The added or edited profile appears on the Mesh HT SSID page.

Profiles > Mobility Switch

Use the following profiles to configure an Dell switch:

 IGMP Snooping — Create and configure the IGMP snooping profiles for VLANs. Refer to “Profiles >

Mobility Switch > IGMP Snooping” on page100 for more information.

 Ethernet Link — Configure autonegotiation, duplex, speed, and flow control for the port.Refer to “Profiles >

Mobility Switch > Ethernet Link” on page101 for more information.

 Port Switching — Create a switching profile that can be applied to any interface, interface group, or a port-

channel. Refer to “Profiles > Mobility Switch > Port Switching” on page102 for more information.

 VLAN — Create a VLAN with the specified configuration parameters. Refer to “Profiles > Mobility Switch >

VLAN” on page103 for more information.

Profiles > Mobility Switch > IGMP Snooping

IGMP snooping allows a network switch to listen in on the Internet Group Management Protocol (IGMP)

interaction between hosts and routers in order to map links to IP multicast streams.

Perform these steps to configure a Mobility Switch > IGMP Snooping profile:

1. Select Profiles > Mobility Switch > IGMP Snooping in the Navigation pane. The details page summarizes

the current profiles of this type.

2. Select the Add button to create a new IGMP Snooping profile, or select the pencil icon next to an existing

profile to edit. Complete the settings as described in Table 44:

Maximum Number of

Spatial Streams Usable

for STBC Transmission

Controls the maximum number of spatial streams usable for STBC transmission. 0 disables

STBC transmission, 1 uses STBC for MCS 0-7. Higher MCS values are not supported.

Maximum Number of

Spatial Streams Usable

for STBC Reception

Controls the maximum number of spatial streams usable for STBC reception. 0 disables

STBC reception, 1 uses STBC for MCS 0-7. Higher MCS values are not supported.

Legacy Stations Yes Allow or disallow associations from legacy (non-HT) stations.

This parameter is enabled by default (legacy stations are allowed).

Max Transmitted A-

MPDU Size

65535 Sets maximum size of a transmitted aggregate MPDU, in bytes.

Specify size in the supported range of 1576 to 65535 bytes.

Table 44 Profiles > Mobility Switch > IGMP Snooping Profile Settings

Field Default Description

General Settings

Folder Top Specify the folder with which the profile is associated. The drop-down menu

displays all folders available for association with the profile.

Name Blank Enter the name of the profile.

Table 43 Mesh > Radio > Mesh HT SSID Profile Settings (Continued)

Field

Defaul

Description