Practices Guide

12 | Configuring AirWave for Global Dell PowerConnect W-Series Infrastructure Dell PowerConnect W-AirWave 7.4 | Best Practices Guide
AirWave Setup
Follow these steps in AMP:
1. Navigate to AMP Setup > General.
2. In the Additional AMP Services section, set Enable AMON Data Collection to Yes, as shown in Figure 4:
Figure 4 AMON Data Collection setting in AMP Setup > General
3. Select Save.
Controller Setup (Master and Local)
SSH into the controller, enter “enable” mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # mgmt-server type amp primary-server <AMP IP>
(Controller-Name) (config) # write mem
CAUTION: Enabling these commands on AOS versions prior to 6.0.1.0 can result in performance issues on the controller. If you
are running previous firmware versions such as AOS 6.0.0.0, you should upgrade to AOS 6.0.1 (to obtain RF utilization metrics) or
6.1 (to obtain RF utilization and classified interferer information) before you enter this command.