Support Manual

2 Dell PowerConnect W-AirWave 7.4 | Supported Infrastructure Devices
 1000, 1040, 1130, 1140, 1200, 1230, 1340, 1250, 1260, 3500 series APs
 Cisco Catalyst 3750G Integrated WLC
 WiSM/WiSM2
Support is
not available for the following products:
 3600 series APs
 7500 series controllers
 Mobility Services Engine
 500, 600 series APs
Support for legacy Cisco devices is described at the end of the document.
Motorola
The following Motorola (formerly Symbol) controllers and autonomous APs are supported for monitoring,
configuration, and software upgrades up to software version 4.3.3:
Controllers
 RFS4000/6000/7000
 WS2000 (validated up to 2.4.5)
 WS5100 (validated up to 3.3.4)
Autonomous APs: 5131, 5181, 7131
Support for legacy Motorola/Symbol devices is described at the end of the document.
Wired Ethernet Switches
Any standalone Ethernet access switch that supports the standard SNMP MIB-II objects for wired switches can
be monitored by AirWave.
AirWave will collect the uptime and name/location/contact information for switches (or any device that supports
SNMP). For port information, AirWave relies on the IF-MIB to collect byte counts.
MAC addresses are collected from the BRIDGE MIB and RFC1213 MIB (ARP table) in order to determine AP
port assignments and identify possible rogue devices on the network.
Some switches have additional support in AirWave:
Cisco
 Automated discovery through SNMP
 Model & software version identification
 CDP neighbor information and extended port error stats
 3750 stack information
Juniper
 Automated discovery through SNMP
 Model & software version identification
 Rogue AP detection is supported using the Q-BRIDGE MIB
NOTE: Motorola 5.x software is not supported by AirWave.