User guide

10 AirWave 7.5.6 | Release Notes
Table 6 below lists resolved issues in AirWave 7.5.1:
Table 7 below lists resolved issues in AirWave 7.5.0:
DE12259 When a radio is in Mesh mode and has active SSIDs, the radio will display with a “Mesh and Access”
role in the AP Monitor page. In addition, the client count now displays correctly.
DE12265 For Aruba controllers that are part of a Master/Local configuration, the Master Controller ID is now
shows on the Local Controller’s monitoring page along with the Master Controller IP.
DE12289 When a user selects the “XML (XHTML) export” link after running a report, the report now displays
correctly in a new tab.
DE12291 When a user mouses over a Campus name, Building name, or Floor Plan name in VisualRF, non-UTF-8
characters now display correctly at the top of the pop-up boxes.
DE12294 Updated kernel (kernel-2.6.18-308.8.1.el5). See the Security section of this document for more details.
DE12295 Updated openssl (openssl-0.9.8e-22.el5_8.4 and openssl-1.0.0-20.el6_2.5). See the Security section of
this document for more details.
DE12300 Fixed a “pre-upgrade check” issue in the reporting of disk space. In some cases, an incorrect value was
reported for the estimated disk space size when determining whether enough disk was available to
upgrade AirWave.
DE12314 Fixed an error that occurred when attempting to disable LWAPP APs. The “Disable” setting is now
pushed correctly.
DE12327 When selecting or viewing APs in VisualRF, Dell APs now display with a “PowerConnect W-AP” label
that prepends the model number.
DE12336 AP 93H BSSIDs are now collected when added to AMP or when the AP is audited. Not having the
correct BSSIDs prevented the users from showing up in AMP. (There is a calculation method for BSSIDs
done in AMP for regular APs. For APs that have at least 1 radio and at least 2 wired ethernet ports, the
AMP must get the BSSIDs from the controller - these SSIDs can't be calculated by any specific
formula.)
Table 6 Resolved Issues in AirWave 7.5.1
ID Description
DE12310 Fixed a regression that in some cases caused confirmation page settings to be applied incorrectly for
Aruba profiles.
Table 7 Resolved Issues in AirWave 7.5.0
ID Description
DE10214 When restoring a backup from the controller into VisualRF, the “Validate” link no longer remains enabled
after it has been clicked.
DE10327 AirWave no longer updates the device state from ‘Importing’ to ‘Mismatched’ before the import is
completed.
DE10454 Added a warning to the confirmation page when changing a group time zone reminding the user that
this change can have an impact on maintenance windows.
DE10479 The Failover server no longer includes a read-only user role.
DE10531 The VisualRF Frequency selection option now works properly for overlay bleed through.
DE10621 On the Master Controller, a confirmation page now displays when you attempt to remove a Managed
AMP. In prior versions, AMP was immediately deleted.
DE10655 When an Aruba Mobility Access Switch is deleted from a stack group, the status message “Deleting
Devices in the Background” no longer remains on the page when there are no devices on the
ap_monitoring page.
Table 5 Resolved Issues in AirWave 7.5.2 (Continued)
ID Description