User guide

AirWave 7.5.6 | Release Notes 15
DE11814 Added a new “Auth” traps category and moved the following auth traps from IDS Events to Auth:
 wlsxNAuthServerReqTimedOut
 authenticationFailure
 wlsxAuthMaxAclEntries
 wlsxAuthMaxBWContracts
 wlsxAuthMaxUserEntries
 wlsxAuthServerIsUp
 wlsxAuthServerReqTimedOut
 wlsxAuthServerTimedOut
 wlsxNAuthMaxAclEntries
 wlsxNAuthMaxBWContracts
 wlsxNAuthMaxUserEntries
 wlsxNAuthMaxXsecUserEntries
 wlsxNAuthServerAllInService
 wlsxNAuthServerIsDown
 wlsxNAuthServerIsUp
 wlsxNAuthServerTimedOut
DE11885 Fixed an issue in which AMP was slow to bring up an Aruba controller. This occurred when the
controller included good SNMP credentials but no CLI credentials or when the controller did not contain
information required for the WMS Offload provisioning.
DE11898 Fixed an issue that caused new_config to be incorrectly deleted. This impacted APs that included
scheduled recurring configuration jobs. When clicking Apply Changes Now through the Configuration
Change Jobs page, the changes were applied correctly, but the scheduled changes were deleted.
DE11991 Fixed an issue that caused Forward Mode, Sig. Qual., and Ch BW values to display incorrectly on the
Clients > Client Detail page.
DE12006 When replacing hardware, if a user does not have access to a folder, then devices in that folder can no
longer be seen under the ‘Devices in Group’ section.
DE12024 When changing credentials on a controller, config_verify_failures is now reset for both the controller and
its thin APs. As a result, if config verification fails due to bad credentials and the user changes those
credentials to correct ones, the configuration for the thin APs can now be verified.
DE12041 Fixed an issue that caused a user-count discrepancy between a folder and an AP within that folder. The
updating folder and group RRD rules now only count clients from SNMP polls. This prevents the
discrepancy between the AP and Folder/Group client count graphs. Previously, clients processed by
traps may have been counted in folder graphs, but not in AP graphs which led to the discrepancy.
DE12058 Fixed a crash in the APs/Devices > List and APs/Devices > Down pages that was caused by a switch
on an AMP that was designated as a “standalone” switch_role.
DE12070 Running AP Controller commands without an <apname> will use an <ip_address> instead.
DE12086 Fixed an issue in which IDS events for IAPs failed to appear in AirWave after upgrading.
DE12094 When monitoring interface bandwidth, AirWave checks the calculated bandwidth against the known
maximum for that interface. However, if that is missing, then the following values will now be used:
 For non-802.11n Aruba thin APs, 100 Mbps
 For 802.11n Aruba thin APs, 1 Gbps
 For all other devices, 10 Gbps
DE12113 The device “Type” label now displays general device information for Alcatel-Lucent devices on the APs/
Devices > Monitor page.
DE12118 Fixed an issue that prevented AirWave from displaying the complete list of clients present on the
controller.
DE12144 Fixed an issue in which a wiring closet name change failed to update.
DE12157 Fixed an issue that occurred when emailing a Rogue Containment Report with the Disable AirWave
Links option enabled. The Classifying Rule and Location columns still linked the user to the AMP that
generated the report. Links are now disabled correctly when this option is selected.
Table 7 Resolved Issues in AirWave 7.5.0 (Continued)
ID Description