User guide

AirWave 7.5.6 | Release Notes 9
Table 4 below lists resolved issues in AirWave 7.5.3:
Table 5 below lists resolved issues in AirWave 7.5.2:
DE12378 Fixed an issue with the custom Capacity report. This report no longer loads slowly, and exporting this
report now works correctly.
DE12388 When AirWave attempts to auto detect a language during login, the default for the “ZH-TW” language
setting now correctly points to Traditional Chinese rather than Simplified Chinese.
DE12400 Updated kernel (kernel-2.6.32-220.23.1.el6). See the Security section of this document for more details.
DE12407 Fixed an issue in which configurations failed to be pushed because the Virtual Controller’s
“all_aps_have_been_read” flag was set to 0. AMP changes this column from 0 to 1 for a swarm to
ensure that configurations are pushed to existing APs when upgrade AMP.
DE12426 The Unused Ports histogram in custom reports now displays properly.
DE12453 In VisualRF, AP135 now displays in the Add Planned AP dialog box for the Sensor device type.
DE12460 Fixed an issue in which AMP pushed incorrect radio antenna gain information to the controller for AP
134. In this particular case, AMP was configured to push radio antenna gain of 802.11bgn radios to “5”
and 802.11an radios to “3.” The result, however, was that AMP had reversed these configurations.
DE12469 ACLs pushed from AirWave are now configured properly. AirWave no longer issues a “no” for “rule”
commands.
DE12562 Fixed a reboot issue that occurred when multiple devices were selected to be modified from the APs/
Devices List page. In this case, when the controller was in Monitor mode, and the AP was in Managed
mode, choosing Reboot resulted in AMP events claiming ‘Rebooting’, but no actual action was being
performed.
DE12572 On the Master Controller, the Groups > List page no longer indicates that groups defined on the MC
groups are ‘Local Groups.’
DE12575 When reviewing the AP_list.xml file on a Cisco 600 LWAPP AP, the “Display Transmit Power” value is no
longer missing for <radio index=”2”>.
US8283 A new graph was introduced on the System > Performance page that displays number of Web server
connections and the current number of database connections over a period of time. See the New
Diagnostics Graph section for more information.
US8712 Added support for additional Cisco devices. See the Cisco Device Support section for more
information.
Table 4 Resolved Issues in AirWave 7.5.3
ID Description
DE12302 Floor plans exported from VisualRF Plan and imported into their VisualRF on AMP properly display all
required APs, switches and building floors. This resolves an issue where some parts of the floor plan
would not appear properly after importing into VisualRF.
DE12838 Fixed an issue with the PopulateFromSNMPPoll migration process. For some deployments, the entire
migration can take multiple hours. As a result other processes were unable to begin or continue while
the migration was being run. This migration is now divided into multiple transactions, so other process
now need only wait until a portion of the migration process is complete before continuing.
DE12386 When upgrading to 7.5, remote APs no longer mismatch after the server comes back online. This
occured because the function controlling the configuration for remote AP authentication toggled to “No”
(NULL) during the upgrade process.
Table 5 Resolved Issues in AirWave 7.5.2
ID Description
DE12256 A VC IP is required in order to enable the Instant “Dynamic RADIUS Proxy” feature. A new error
message displays when a user attempts to push a configuration in which the Instant Dynamic RADIUS
Proxy feature is enabled, but a VC IP is not provided.
Table 3 Resolved Issues in AirWave 7.5.4 (Continued)
ID Description