User's Manual

Dell PowerConnect W-AirWave 7.4 | User Guide Using VisualRF | 263
Figure 195 The VisualRF > Setup Page
To enable VisualRF and tune memory and performance, navigate to the Server Settings section on this page. The
settings in this section are detailed in Table 139:
Table 139 Server Settings Section of the VisualRF > Setup Page
Setting Default Description
Enable VisualRF Engine No Enables or disables the VisualRF engine. This setting must be enabled to use VisualRF.
If you do not have a license for VisualRF, this page will not appear.
Enable Multi-floor
Bleed-Through
Yes Enables or disables calculating the impact APs on floors above and below the currently
viewed floor in the Quick View.
Dynamic Attenuation Yes Incorporate AP to AP readings as well as site survey information and dynamically
recalculate the path loss of each radio to every grid cell on the floor plan, increasing
coverage and location accuracy.
Use Metric Units No Instructs the VisualRF engine to display all units of measurements in metric