User's Manual

96 | Configuring and Using Device Groups in AirWave Dell PowerConnect W-AirWave 7.4 | User Guide
Figure 56 Groups > Cisco WLC Config > Management Navigation Illustration
Configuring Group PTMP Settings
The Groups > PTMP configuration page configures Point-to-Multipoint (PTMP) for all subscriber and base
stations in the device group. Subscriber stations must be in the same group as all base stations with which they
might connect.
Perform the following steps to configure these functions.
1. Go to the Groups > List page and select the group for which to define PTMP settings by selecting the group
name. Alternatively, select Add from the Groups > List page to create a new group, define a group name. In
either case, the Monitor page appears.
2. Select the PTMP tab in the AirWave navigation menu. Figure 57 illustrates this page.
Figure 57 Groups > PTMP Page Illustration
3. Define the settings on this page. Table 66 describes the settings and default values.
4. Select Save and Apply when configurations are complete to make them permanent, or select Save to retain
these settings prior to pushing to controllers at a later time.
Table 66 Groups > PTMP Fields and Default Values
Setting Default Description
802.11a Radio Channel 58 Selects the channel used for 802.11a radios by the devices in this group.
802.11g Radio Channel 10 Selects the channel used for 802.11g radios by the devices in this group.
Channel Bandwidth 20 Defines the channel bandwidth used by the devices in this group.
Network Name Wireless Network Sets the Network name, with a range of length supported from two to 32
alphanumeric characters.
Network Secret None Sets a shared password to authenticate clients to the network.