Configuration manual
Table Of Contents
- Executive Summary
- Introduction
- Network Topology
- Applicable Hardware and Software Versions
- MAC Authentication with W-ClearPass and Dell Networking 7024P Switch
- OnGuard posture enforcement with Dell Networking 7024P Switch
- Appendix A
Dell Networking W-
Series ClearPass Configuration Guide
12
Figure 4. MAC Authentication 7024P Switch - Authentication Configuration
There are likely other ports on the switch that do not require Authentication. For those ports at this
time it is recommended to force the port interface into Authorized mode.
Under Interface Parameters, choose the port number from the dropdown list in the Interface field
Choose Authorized from the dropdown list in the Admin Interface Control field
All other fields can remain default
Repeat the above for all ports requiring access without Authentication
NOTE: Administrators can edit multiple ports at one time by using the Show All configuration page
under Authentication.
Click Apply
Save your configuration to the running configuration
This completes the steps required for Mac Authentication on the Dell Networking 7024P.
For additional information and CLI examples, please refer to the Dell Networking 7000 Series Switch
User’s Configuration Guide.