User's Manual
362 | Administration Dell Networking W-ClearPass Guest 6.4 | User Guide
Field Description
When a poll is run, you may click Show Details in the Controllers list to view the updated
configuration. For more information, see "AirGroup Controllers" on page 358. Automatic
polling is run only on the publisher node.
Group Names Enter names of shared groups that should be available in the Shared Groups field for users
to choose from when they share a device. If additional user groups are also entered by
users when they share a device, the list in the configuration is automatically updated to
capture these fields. Removing a group name from this list does not remove it from other
shared group lists.
When you type a name for the group in the Group Names field, press the Enter key, and
click Save, the group is created in the system and appears as a "tag". For more information,
see "About AirGroup Time-Based Sharing" on page 75.
Each group name may not exceed 64 characters. A maximum of 32 group names may be
entered. The maximum character limit for the list is 320 characters (including comma
separators).
Network Interface Interface AirGroup will use to send outbound notification messages. To enable using a
virtual IP address, select the appropriate interface. Options include:
l Automatic — Automatically chooses the appropriate source IPaddress; either the
management port or the data port, depending on the controller's IP address.
l Management port [MGMT] — Always uses the management port as the source
address.
l Data/External port [DATA] — Always uses the data port as the source address.
Timeout Number of seconds after which an attempt to send an AirGroup message will time out.
Attempts Maximum number of times the system should attempt to send an AirGroup message.
AirGroup Logging Choose one of the following options:
l Disabled—Do not log AirGroup related events
l Standard (Recommended)—Log basic information
l Extended—Log additional information
l Debug—Log debug information
l Trace—Log all debug information
See also:
l "AirGroup Diagnostics" on page 362
l "AirGroup Services " on page 358
AirGroup Diagnostics
The AirGroup Diagnostics form lets you perform several diagnostic actions. To access this form, go to
Administration >AirGroup Services >Configuration, and then click the AirGroup Diagnostics link in the
upper-right corner. The AirGroup Diagnostics form opens.