User's Manual

388 | Administration Dell Networking W-ClearPass Guest 6.4 | User Guide
Fault Reason for Fault
Client.BadRequest Request exceeds the maximum allowable size. Increase the
maximum SOAP request size, or reduce the size of the request.
Client.Authentication Invalid username or password. Check that the credentials supplied
are correct.
Client.MethodNotFound The SOAP method request was not found.
Client.Error Another non-specific client error occurred. Check the
<faultstring> for more details.
Server.MethodNotImplemented The SOAP method requested is not implemented.
Server.Error An error occurred while attempting to convert data, or another non-
specific server error occurred. Check the <faultstring> for more
details.
Table 101: Fault Codes and Descriptions
Certain conditions might also cause errors that are not reported as a fault. These cases are typically caused by
errors in constructing the SOAP request. In these cases, a non-XML result may be returned; check the body of
the result, or the application log for details about the cause of the error.
Using the SOAPAPI
This section describes how to access, configure, and debug Web Services, create a SOAP API operator, and
access the WSDL.
Accessing SOAP Web Services
Use the List Web Services command link available from the Administration page, or go to Administration >
Web Services, to access the SOAP Web Services user interface.
Configuring SOAP Web Services
Use the Configure Web Services command link to make changes to system settings affecting the SOAP API.