Installation guide

Dell PowerConnect W-IAP175 Outdoor Instant Access Point | Installation Guide 27
Connecting a Power Cable to the W-IAP175AC
1. Remove the protective cap on the power interface.
2. Insert the power cable connector into the power interface and hand-fasten the waterproof cover.
3. Water-proof the power cable connection with PVC insulation tape, adhesive insulation tape and strap.
 AC power source specifications (at W-IAP175 interface): 100-240Vac, 100W
 AC power cable specifications (when using AC connector kit and custom cable): minimum voltage/current
rating 250V/1A, diameter 6-12mm, rated for outdoor use
Cable Connection Steps
1. Remove the protective cap on the power interface.
2. Insert the power cable connector into the power interface and hand-fasten the waterproof cover.
3. Water-proof the power cable connection with PVC insulation tape, adhesive insulation tape and strap.
Attaching the Solar Shield to the W-IAP175
Attach the solar shield to the W-IAP175 by using the four M4 x16 (with flat and spring washers).
Figure 25 Attaching the Solar Shield to the AP
AP175_07
AP175_08