Users Guide

ALERT! Cover was previously removed.
14. To reset the chassis intrusion detector, enter the System Setup program and reset Chassis Intrusion to Not
Detected.
See "Using the System Setup Program" in your User's Guide for instructions.
NOTE: If a setup password has been assigned by someone else, contact your network administrator for
information on resetting the chassis intrusion detector.
15. Update your system configuration information.
For a diskette drive, update the Diskette Drive category on Page 1 of the System Setup screens to reflect the size
and capacity of your new diskette drive. (For more information, see "Using the System Setup Program" in your
User's Guide.)
For EIDE CD-ROM drives, set the appropriate Drive category (0 or 1) under IDE Drives: Secondary to Auto.
16. Verify that your system works correctly.
See Running the Dell Diagnostics for troubleshooting any problems that may occur. Use the following guidelines
to determine which test to use:
If you installed a diskette drive, test it by running all of the subtests in the Diskette Drives Test
Group of the Dell Diagnostics.
If you installed a CD-ROM drive, see the documentation that came with the drive for instructions on
loading device drivers and using the drive. If it is an EIDE CD-ROM drive, test it by running all of
the subtests in the IDE CD-ROM Drives Test Group of the Dell Diagnostics.
If you installed a tape drive, perform a tape backup and verification test with the drive as instructed in
the tape-drive software documentation that came with the tape drive.
NOTE: The tape drives sold by Dell come with their own operating software and documentation.
After you install a tape drive, refer to the documentation that came with the drive for instructions on
installing and using the tape drive software.
Installing a Hard-Disk Drive in the Internal Hard-Disk Drive Cage
Install a hard-disk drive in the hard-disk drive cage as follows:
1. Remove the computer cover as instructed in Removing the Computer Cover.
CAUTION: See Protecting Against Electrostatic Discharge.
2. Remove the front bezel according to the instructions in Removing and Replacing the
Front Bezel.
3. Open the drive cage door.
If any hard-disk drives are already installed in the bracket, disconnect the DC power cable and interface cable
from each drive.
Grasp the handle of the drive bay door on the front of the chassis, and pull out and down until the arms on the
drive cage door (see Figure 8, Removing the Hard-Disk Drive Cage) disengage from the tabs on the bracket. This
action pulls the cage out of the drive bay about 1 to 3 inches.
Figure 8. Removing the Hard-Disk Drive Cage