Users Guide

The driver failed in its attempt to register the host adapter with IntranetWare. The file server may not have enough
memory.
003 Invalid command line option entered > option
An invalid option was entered on the command line. The invalid option that was entered is displayed.
004 Invalid command line, please enter correctly
The driver was unable to understand the command line options you entered. Be sure you have entered these options
correctly.
Host-Adapter-Specific Error Codes
The following error codes alert you to error conditions caused by factors related to the host adapter:
200 No host adapter found for this driver to register
No Adaptec 78xx host adapter was found in your system for the driver to register. Be sure the host adapter is properly
configured and properly seated in the slot.
203 Invalid 'device' setting
You have entered an invalid slot setting on the command line. You can only enter slot numbers for valid host adapters.
If you load without the slot option, you will be prompted to enter a valid value.
204 Invalid 'verbose' setting, use 'y'
You can only enter y for this option (verbose=y).
205 Invalid 'removable' setting, use 'off'
You can only enter off for this option (removable=off).
206 Invalid 'fixed_disk' setting, use 'off'
You can only enter off for this option (fixed_disk=off).
208 SCSI present but not enabled/configured for PCI
A host adapter is present, but its bus or device entry has not been enabled.
Installation for Novell NetWare 5.0
This section provides information on installing the SCSI drivers for the Novell NetWare 5.0 operating system.
Instructions assume that NetWare 5.0 is installed and operational.
Creating the NetWare 5.0 SCSI Driver Diskette
If you have not already done so, use the Dell OpenManage Server Assistant CD to create a NetWare 5.0 SCSI Driver
diskette. See Using the Dell OpenManage Server Assistant
CD for instructions on creating the diskette.
Uninstalling a SCSI Driver
If you are replacing an existing driver (for example, because it has become corrupted or an upgrade has become
available), you must first remove the installed driver. To remove a driver, follow these steps: