User guide

3-4 User’s Guide

This section provides information on installing the SCSI drivers for the Novell
NetWare 5.1 operating system. Instructions assume that NetWare 5.1 is installed and
operational.
NOTE: Use these procedures only if you did not use Server Setup from the Dell Open-
Manage Server Assistant CD to install your operating system.
!"#$
If you have not already done so, use the
Dell OpenManage Server Assistant
CD to
create a NetWare 5.1 SCSI driver diskette.

If you are replacing an existing driver (for example, because it has become corrupted
or an upgrade has become available), you must first remove the installed driver. To
remove a driver, perform the following steps:
1. At the initial NetWare screen, press <Alt><Esc> to display the NetWare console
screen.
2. At the server prompt, type nwconfig and press <Enter>.
The NetWare Configuration screen appears, displaying the Configuration
Options menu.
3. At the Configuration Options menu, highlight Driver Options and press
<Enter>.
4. At the Driver Options menu, highlight Configure disk and storage device
drivers and press <Enter>.
5. At the Additional Driver Actions menu, highlight Unload an additional driver
and press <Enter>.
6. At the Selected Disk Drivers menu, highlight the driver that you want to uninstall
and press <Enter>.
7. At the message Driver xxx successfully unloaded, press <Enter>.
The Additional Driver Actions menu appears.
From the Additional Driver Actions menu, you can repeat steps 5 through 7 to unin-
stall an additional driver, start with step 5 of the next procedure to install a driver, or
press <Esc> to exit.