Users Guide

A-4 Installation and Troubleshooting Guide
3. Locate the password jumper (labeled PASSWORD CLEAR) on the system board
(see Figure A-2).
4. Place a jumper plug on the PASSWORD CLEAR jumper.
5. Replace the system cover, and then reconnect the system to an electrical outlet
and power on.
The system password is cleared. Do not set a new system password at this time.
NOTE: If you assign a new supervisor and/or user password with the jumper plug still
in place, the system disables the new password(s) the next time it boots.
6. Repeat steps 1, 2, and 3.
7. Remove the jumper plug from the PASSWORD CLEAR jumper.
8. Replace the system cover, and then reconnect the system and peripherals to
their electrical outlets and power them on.
9. Assign a new supervisor and/or user password.
To assign a new supervisor password using the System Setup program, see
“Assigning a Supervisor Password” in the User's Guide. To assign a new user
password using the System Setup program, see “Assigning a User Password” in
the User's Guide.
4D338bk0.book Page 4 Wednesday, August 12, 2015 12:40 PM