Users Guide

9-4 Installation and Troubleshooting Guide
To remove the 3.5-inch diskette drive or the CD-ROM drive, perform the following
steps:
1. Re m o v e t h e c ov e r.
2. Remove the power cables from both the 3.5-inch diskette drive and the CD-ROM
drive.
3. Remove the interface cable from the back of the 3.5-inch diskette drive.
4. Remove the three screws securing the 3.5-inch diskette drive bracket and the
CD-ROM drive bracket to the floor of the chassis.
5. Lift the 3.5-inch diskette drive and bracket out of the chassis and set it on a
smooth, nonconducting work surface (see
Figure 9-4).
Figure 9-4. Diskette Drive and CD-ROM Drive Removal
6. If you are also removing the CD-ROM drive, remove the IDE cable from the back
of the CD-ROM drive.
7. If you are also removing the CD-ROM drive, lift the CD-ROM drive and its bracket
out of the chassis.
8. Remove the faulty drive (either the 3.5-inch diskette drive or the CD-ROM drive)
from its mounting bracket by removing four screws (see
Figure 9-4).
To install these drives, reverse the order of the steps.
3.5-inch diskette drive
screws (3)
screws for mounting
diskette drive (4)
bracket for diskette drive
CD-ROM drive
bracket for
CD-ROM drive
chassis
4D338bk0.book Page 4 Wednesday, August 12, 2015 12:40 PM