Service Manual

Optional Front Bezel
To remove the optional front bezel of the system, perform the following steps:
CAUTION: See "Safety Instructions" before working inside your system.
1. Press the retention tab on each end of the bezel and remove the bezel from the chassis (see Figure 3).
Figure 3. Front-Bezel Removal
1 Tabs
2 Nameplate
3 Status indicators (3)
NOTICE: When replacing the front bezel, ensure that the bezel is oriented so that its status
indicators are positioned just above the Dell nameplate in the center of the bezel.
Control-Panel Assembly
To remove the control-panel assembly, perform the following steps.
NOTICE: See "Protecting Against
Electrostatic Discharge."
CAUTION: See "Safety Instructions" before working inside your system.
Figure 4. Control-Panel Assembly Removal
1 Control panel
2 Screws (2)