Service Manual

NOTE: When you reinstall a replacement IDE hard-disk drive, ensure the drive has the identical part
number and ensure any jumpers are at the settings you recorded.
Diskette Drive and CD-ROM Drive Removal
CAUTION: See "Safety Instructions" before working inside your system.
To remove the 3.5-inch diskette drive or the CD-ROM drive, perform the following steps:
1. Remove the cover
.
2. Remove the power cables from both the 3.5-inch diskette drive and the CD-ROM drive.
3. Remove the interface cable from the back of the 3.5-inch diskette drive.
4. Remove the three screws securing the 3.5-inch diskette drive bracket and the CD-ROM drive bracket to
the floor of the chassis.
5. Lift the 3.5-inch diskette drive and bracket out of the chassis and set it on a smooth, nonconducting
work surface (see Figure 6).
Figure 6. Diskette Drive and CD-ROM Drive Removal
1 3.5-inch diskette drive
2 Screws (3)
3 Screws for mounting diskette drive (4)
4 Bracket for diskette drive
5 CD-ROM drive
6 Bracket for CD-ROM drive