Manualshelf

Service Manual

ManualsBrandsDell ManualsStereo SystemPowerEdge 350
31323334353637383940
7 Chassis
6. If you are also removing the CD-ROM drive, remove the IDE cable from the back of the CD-ROM drive.
7. If you are also removing the CD-ROM drive, lift the CD-ROM drive and its bracket out of the chassis.
8. Remove the faulty drive (either the 3.5-inch diskette drive or the CD-ROM drive) from its mounting
bracket by removing four screws (see Figure 6).
Hard-Disk Drive
Each hard-disk drive is mounted in a mounting bracket. The mounting bracket is secured to slots in the
chassis front panel and to two snap-in posts at the back of the mounting bracket.
Hard-Disk Drive Removal
To remove a faulty hard-disk drive and its mounting bracket, perform the following steps.
CAUTION: See "Safety Instructions" before working inside your system.
NOTICE: See "Protecting Against Electrostatic Discharge."
1. Shut down the system and disconnect the cables.
2. Remove the optional bezel
.
3. If you have not already done so, remove the cover.