Service Manual

Expansion Card Replacement
To install a replacement expansion card, perform the following steps.
CAUTION: See "Safety Instructions" before working inside your system.
NOTICE: See "Protecting Against Electrostatic Discharge."
1. Remove the cover
, if it is not already removed.
2. Prepare the replacement expansion card for installation.
See the documentation that came with the expansion card for information on configuring the card,
making internal connections, or otherwise customizing the card for the system.
3. To remove a PCI retention panel (if it is not already removed), remove the two screws securing it to the
chassis back panel (see Figure 12
).
4. Remove the riser board, together with installed expansion cards, from the system board.
5. To install the replacement expansion card, insert the card-edge connector firmly into the socket on the
riser board.
6. Connect any cables that should be attached to the card.
See the documentation that came with the card for information about cable connections.
7. Install the riser board into the chassis.